Reorder --ifile pseudo-sdr after the "none" SDR so that a build with no real
SDR support defaults to "none" not --ifile
If the "none" SDR was selected and network mode is not enabled, tell the
user about the problem rather than just failing to do anything useful.
Update all the SDR implementation to use it.
This was getting pretty ugly with code getting copy&pasted in all the SDR
implementations. Unify it all and give it a simpler API. Linked list works out
much simpler than the circular buffer. Also, simplify copying the overlap region
around by just using a separate buffer (it's only a few hundred bytes long, so
the double copy is not a big deal).
The commit provides a basic implementation of support for LimeSDR USB
receivers based on LMS7002 chip. The solution has several limitations:
- passing parameters for tune LimeSDR receiver via command-line
options is not implemented;
- only hardcoded configuration is used (channel 0 of lower band LNA,
LMS_FMT_I16 format, gain, bandwidth and timeout);
- only one device is supported and it is not possible to select a
desired one in case if several devices are connected to the host.
Test: compare the output of the program for RTL and LimeSDR receivers.
Environment:
- RTL2832SDR dongle;
- LMS7002M based USB LimeSDR board;
- 800MHz-2200MHz omnidirectional antenna with SMA connector.
Procedure:
- connect RTL dongle to the host and start the program with the
following parameters:
$ ./dump1090 --device-type rtlsdr --interactive
- wait until several planes will be detected;
- stop the program, connect the LimeSDR board to the host and restart
the program with the following parameters:
$ ./dump1090 --device-type limesdr --interactive
- ensure that the same planes are detected.
Acceptance criteria: the same planes are detected using both receivers
and track information matches with information from the
FlightRadar24 application.
Signed-off-by: Gluttton <gluttton@ukr.net>
--fix --fix was a poor choice for this, as some existing configs
happened to specify --fix twice but only expected 1-bit correction.
So move 2-bit correction to a separate option.
"--fix" or "--fix --fix" now gives 1-bit correction.
"--fix-2bit" or "--fix --fix-2bit" or "--fix-2bit --fix" gives 2-bit correction.
Version bump to 3.8.2~dev
nb: messages with a correctable 2-bit error are only forwarded to network
clients that have enabled verbatim mode (and they will be forwarded with
the 2-bit error still present, so the downstream client must apply its own
correction if desired)
Oliver Jowett
Gluttton
Rosen Penev
Carlos Pizarro
Oliver Jowett
Michael Tatarinov
maxried